Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRREAR SIDE DOOR WINDOW INNER WEATHERSTRIP REPLACEMENT
2009 Chevrolet Traverse FWD V6-3.6L
Rear Side Door Window Inner Weatherstrip Replacement
2009 Chevrolet Traverse FWD V6-3.6LSECTION Rear Side Door Window Inner Weatherstrip Replacement
Rear Side Door Window Inner Weatherstrip Replacement
Removal Procedure
1. Open the door.
2. Lower the window to the full down position.
3. Grasp the window weatherstrip in the center.
Pull downward until the window weatherstrip fully releases from the door frame.
4. Remove the window weatherstrip (1) from the front door.
Installation Procedure
1. Position the window weatherstrip (1) to the door starting in the corner.
2. Firmly seat the window weatherstrip to the door, working out in both directions.
3. Inspect the window to ensure the weatherstrip is properly positioned.
4. Inspect the window for proper operation.
5. Close the door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.