Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRREAR SIDE DOOR WINDOW CHANNEL REPLACEMENT
2009 Chevrolet Traverse FWD V6-3.6L
Rear Side Door Window Channel Replacement
2009 Chevrolet Traverse FWD V6-3.6LSECTION Rear Side Door Window Channel Replacement
Rear Side Door Window Channel Replacement
Removal Procedure
1. Pull the weatherstrip/run channel (1) from the window frame opening.
2. Carefully twist and pull downward on the weatherstrip run channel releasing it from the upper door frame.
3. Remove the weatherstrip/run channel from the door.
Installation Procedure
Important: Install the weatherstrip/run channel by fitting both corners to the upper door frame and then pushing inward on the sides.
1. Install the weatherstrip/run channel (1) to the door.
2. Press the weatherstrip/run channel (1) into the window frame opening.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.