Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTUNE-UP AND ENGINE PERFORMANCE CHECKSIGNITION TIMINGNUMBER ONE CYLINDERLOCATIONS
2009 Chevrolet Traverse FWD V6-3.6L
Number One Cylinder: Locations
2009 Chevrolet Traverse FWD V6-3.6LSECTION Locations
NUMBER 1 CYLINDER LOCATION
The right bank of cylinders are number 1-3-5 and the left bank of cylinders are 2-4-6.
NOTE: Right hand (RH) and left hand (LH) designation are viewed from the rear of the engine or from the driver seat inside the vehicle.
For ignition system firing order, Firing Order
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.