Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE 2WD V8-6.0L HYBRIDREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGSUSPENSION POSITION CALIBRATIONSUSPENSION POSITION CALIBRATION (WITH Z95)
2009 Chevrolet Tahoe 2WD V8-6.0L Hybrid
Suspension Position Calibration (With Z95)
2009 Chevrolet Tahoe 2WD V8-6.0L HybridSECTION Suspension Position Calibration (With Z95)
Suspension Position Calibration (With Z95)
Automatic Level Control (ALC) Trimset Procedure
If the system is functioning abnormally, performing the Bumpstop and ALC Trimset recalibration procedures may correct the condition. When a system component has been replaced, the Bumpstop setup and ALC Trimset procedures must be performed.
1. Place the vehicle on a flat level surface. Ensure that the suspension is in the normal resting position. With a scan tool, perform the ALC Trimset procedure by following the screen prompts.
2. Raise the vehicle off the ground enough to allow the suspension to fully extend. With a scan tool, perform the suspension Bumpstop setup procedure by following the screen prompts.
Once the process has been completed, the system should be fully functional.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.