Body Side Window Replacement

2009 Chevrolet Silverado 2500 2WD V8-6.6L DSL TurboSECTION Body Side Window Replacement


Body Side Window Replacement

Removal Procedure





1. Place tape from body side to window to hold in place.
2. Remove the side access door trim panel. Refer to Rear Side Access Door Trim Panel Replacement (Service and Repair) .
3. Disconnect the window latch.
4. Remove the bolts from the hinges.
5. Remove the tape and window from the vehicle.



Installation Procedure





1. Position the window and tape into position.
Caution: Refer to Fastener Caution (Fastener Caution) .
2. Install the bolts to the hinges.

Tighten the bolts to 10 Nm (89 lb in).

3. Install the window latch.
4. Remove the tape and inspect the window.
5. Install the side access door trim panel. Refer to Rear Side Access Door Trim Panel Replacement (Service and Repair) .


RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.