Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009SILVERADO 2500 2WD V8-6.6L DSL TURBOREPAIR AND DIAGNOSISSPECIFICATIONSFLUID TYPE SPECIFICATIONSENGINE OIL
2009 Chevrolet Silverado 2500 2WD V8-6.6L DSL Turbo
Engine Oil
2009 Chevrolet Silverado 2500 2WD V8-6.6L DSL TurboSECTION Engine Oil
WHAT KIND OF ENGINE OIL TO USE
LOOK FOR THESE THINGS:
Oils designated as API CJ-4 are required for your vehicle. The CJ-4 designation can appear either alone or in combination with other American Petroleum Institute (API) designations, such as API CJ-4/SL. These letters show API levels of quality.
SAE 15W-40 is best for your vehicle. When it is very cold, below 0°F (-18°C), you should use SAE 5W-40 to improve cold starting.
These numbers on the oil container show its viscosity, or thickness. Do not use other viscosity oils such as SAE 10W-30, SAE 10W-40, or SAE 20W-50.
NOTICE: Use only engine oils that have the designation CJ-4 for the diesel engine. Failure to use the recommended oil can result in engine damage not covered by your warranty.
ENGINE OIL ADDITIVES ENGINE OIL FLUSHES
Do not add anything to the oil. The recommended oils with the API service symbol are all you need for good performance and engine protection. Engine oil flushes are not recommended and could cause engine damage not covered by the vehicle warranty.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.