Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009MALIBU V6-3.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORLOCATIONS
2009 Chevrolet Malibu V6-3.6L
Oil Pressure Sensor: Locations
2009 Chevrolet Malibu V6-3.6LSECTION Locations
Powertrain Component Views
Front and Rear of Engine (LY7)
1 - Ignition Coil 1
2 - Ignition Coil 3
3 - Ignition Coil 5
4 - Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1
5 - Knock Sensor (KS) 2
6 - Starter Solenoid (Part of Starter Motor)
7 - Starter Motor
8 - Knock Sensor (KS) 1
9 - Engine Oil Pressure (EOP) Switch
10 - Crankshaft Position (CKP) Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.