Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009MALIBU V6-3.6LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRREAR TOE ADJUSTMENT
2009 Chevrolet Malibu V6-3.6L
Rear Toe Adjustment
2009 Chevrolet Malibu V6-3.6LSECTION Rear Toe Adjustment
Rear Toe Adjustment
1. Loosen the inner toe link cam bolt and nuts.
2. Rotate the cam bolt to the required toe specification settings. Refer to Wheel Alignment Measurement (Service and Repair).
Caution: Refer to Fastener Caution (Fastener Caution).
3. Maintain the toe setting while tightening the cam bolt nut.
Tighten the rear suspension adjustment link lock nut to 110 Nm (81 lb ft).
4. Check the toe setting after tightening.
5. Adjust the toe setting if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.