Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009IMPALA V6-3.9LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULDRIVEN SPROCKET SUPPORT ASSEMBLY REMOVAL
2009 Chevrolet Impala V6-3.9L
Driven Sprocket Support Assembly Removal
2009 Chevrolet Impala V6-3.9LSECTION Driven Sprocket Support Assembly Removal
Driven Sprocket Support Assembly Removal
1. With your fingers, insert two 13 mm channel plate bolts (434) into the driven sprocket support assembly (609).
2. Grasp the bolts and lift the support assembly from the case.
3. Remove the thrust washer (611) from the second clutch housing. The washer may be stuck to the support assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.