Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009IMPALA V6-3.9LREPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSMAINTENANCE INDICATOR RESET
2009 Chevrolet Impala V6-3.9L
Maintenance Indicator Reset
2009 Chevrolet Impala V6-3.9LSECTION Maintenance Indicator Reset
GM Oil Life System Resetting
When the system has calculated that oil life has been diminished, it will indicate that an oil change is necessary. A CHANGE ENGINE OIL SOON message will come on. Change the engine oil as soon as possible within the next 600 miles (1 000 km). It is possible that, if driving under the best conditions, the oil life system may not indicate that an oil change is necessary for over a year. However, the engine oil and filter must be changed at least once a year and at this time the system must be reset.
If the system is ever reset accidentally, change the engine oil at 3,000 miles (5 000 km) since last oil change.
How to Reset the Engine Oil Life System
To reset the Engine Oil Life System, do the following:
1. Display the OIL LIFE REMAINING on the driver information center (DIC).
2. Press and hold the SET/RESET button on the DIC for more than five seconds. The oil life will change to 100 percent.
If the CHANGE ENGINE OIL SOON message comes back on when you start the vehicle the Engine Oil Life System has not reset. Repeat the procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.