Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009HHR L4-2.4LREPAIR AND DIAGNOSISMAINTENANCEFUSES AND CIRCUIT BREAKERSFUSELOCATIONSFLOOR CONSOLE FUSE BLOCK
2009 Chevrolet HHR L4-2.4L
Floor Console Fuse Block
2009 Chevrolet HHR L4-2.4LSECTION Floor Console Fuse Block
FLOOR CONSOLE FUSE BLOCK
The floor console fuse block is located on the passenger side of the floor console behind the forward panel. The panel has four clips, one in each corner. Pull the panel to disconnect the four clips, and access the fuses. Use the fuse puller to remove fuses.
FUSES USAGE
Fuse 1 Fuse Puller
Fuse 2 Empty
Fuse 3 Empty
Fuse 4 Empty
Fuse 5 Empty
Fuse 6 Amplifier
Fuse 7 Cluster
Fuse 8 Ignition Switch, PASS-Key III+
Fuse 9 Stoplamp
Fuse 10 Heating, Ventilation, Air Conditioning, PASS-Key III+
Fuse 11 Empty
Fuse 12 Spare
Fuse 13 Airbag
Fuse 14 Spare
Fuse 15 Windshield Wiper
Fuse 16 Climate Control System, Ignition
Fuse 17 Window Retained Accessory Power
Fuse 18 Empty
Fuse 19 Electric Power Steering, Steering Wheel Control
Fuse 20 Sunroof
Fuse 21 Spare
Fuse 22 Empty
Fuse 23 Audio System
Fuse 24 XM Radio, OnStar
Fuse 25 Engine Control Module, Transmission Control Module
Fuse 26 Door Locks
Fuse 27 Interior Lights
Fuse 28 Steering Wheel Control Illumination
Fuse 29 Power Windows
RELAYS USAGE
Relay 30 Climate Control System
Relay 31 Empty
Relay 32 Retained Accessory Power (RAP)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.