SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009HHR L4-2.4LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER BLOCK ASSEMBLYENGINE BLOCK HEATERSERVICE AND REPAIRCOOLANT HEATER REPLACEMENT
2009 Chevrolet HHR L4-2.4L

Coolant Heater Replacement

2009 Chevrolet HHR L4-2.4LSECTION Coolant Heater Replacement



Coolant Heater Replacement (LE5, L61) (2.4L, 2.2L)

Removal Procedure




1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair) for the 2.0L engine or Air Cleaner Assembly Replacement (Service and Repair) for the 2.2L or 2.4L engine.
2. Disconnect the coolant heater cord.




3. Remove the coolant heater bolt.
4. Remove the coolant heater.

Installation Procedure




1. Install the coolant heater.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the coolant heater bolt and tighten to 10 Nm (89 lb in).




3. Connect the coolant heater cord.
4. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair) for the 2.0L engine or Air Cleaner Assembly Replacement (Service and Repair) for the 2.2L or 2.4L engine.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.