Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009HHR L4-2.2LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULTORQUE CONVERTER INSTALLATION
2009 Chevrolet HHR L4-2.2L
Torque Converter Installation
2009 Chevrolet HHR L4-2.2LSECTION Torque Converter Installation
Torque Converter Installation
Special Tools
J 21366 - Torque Converter Holding Strap
For equivalent regional tools, refer to Special Tools (Tools and Equipment).
1. Install a new turbine shaft O-ring (41) on the end of the turbine shaft.
Warning
The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.
2. Install the torque converter onto the transmission.
3. Install the J 21366 - holding strap.
4. Remove the transmission from the holding fixture.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.