Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009HHR L4-2.2LREPAIR AND DIAGNOSISDIAGRAMSELECTRICAL DIAGRAMSPOWERTRAIN MANAGEMENTSYSTEM DIAGRAM
2009 Chevrolet HHR L4-2.2L
System Diagram
2009 Chevrolet HHR L4-2.2LSECTION System Diagram
ENGINE CONTROLS SCHEMATICS
Controlled/Monitored Subsystem References
Engine Data Sensors - 5-Volt and Low References
Engine Data Sensors - Pressure, Temp, and MAF/IAT
Engine Data Sensors - APP and TAC
Engine Data Sensors - HO2S
EVAP Controls
Fuel Controls
Ignition Controls - Ignition System
Ignition Controls - Sensors
Secondary Air Injection (AIR) System - 2.2L (NU6)
Power, Ground, MIL, and DLC
Locations: The locations for the Connectors, Grounds, Splices, and Grommets shown within these diagrams can be found via their numbers at Vehicle Locations. Locations
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.