Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-7.0LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYSERVICE AND REPAIRBATTERY REPLACEMENT
2009 Chevrolet Corvette V8-7.0L
Battery Replacement
2009 Chevrolet Corvette V8-7.0LSECTION Battery Replacement
Battery Replacement (LS7 or LS9) (7.0L or 6.2L SC)
Removal Procedure
1. Open the RH rear compartment storage bin to access the battery.
2. Disconnect the battery vent hose.
3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LS7 or LS9) (Service and Repair)Battery Negative Cable Disconnection and Connection (LS3) (Service and Repair).
4. Disconnect the positive battery cable.
5. Remove the battery hold down retainer nuts and retainer.
6. Remove the battery.
Installation Procedure
1. Install the battery.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the battery hold down retainer and bolts and tighten to 18 Nm (13 lb ft).
3. Connect the positive battery cable and tighten the bolt to 15 Nm (11 lb ft).
Important: Replacement batteries may require the vent plug in the battery vent hole to be moved from one end of the battery to the other to permit vent tube installation per original design.
4. Connect the battery vent hose.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LS7 or LS9) (Service and Repair)Battery Negative Cable Disconnection and Connection (LS3) (Service and Repair).
6. Close the RH rear compartment storage bin.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.