Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-7.0LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYBATTERY TRAYSERVICE AND REPAIR
2009 Chevrolet Corvette V8-7.0L
Battery Tray: Service and Repair
2009 Chevrolet Corvette V8-7.0LSECTION Service and Repair
Battery Tray Replacement
Removal Procedure
1. Remove the battery. Refer to Battery Replacement (LS7 or LS9) (Service and Repair)Battery Replacement (LS3) (Service and Repair).
2. Remove the battery tray bolts.
3. Remove the battery tray.
Installation Procedure
1. Install the battery tray.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the battery tray bolts.
Tighten the battery tray bolts to 12 Nm (106 lb in).
3. Install the battery. Refer to Battery Replacement (LS7 or LS9) (Service and Repair)Battery Replacement (LS3) (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.