Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-7.0LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSANTITHEFT MOTION SENSORSERVICE AND REPAIR
2009 Chevrolet Corvette V8-7.0L
Antitheft Motion Sensor: Service and Repair
2009 Chevrolet Corvette V8-7.0LSECTION Service and Repair
Theft Deterrent Sensor Replacement
Removal Procedure
1. Remove the windshield upper garnish molding. Refer to Windshield Upper Garnish Molding Replacement (Service and Repair).
2. Pull on the intrusion sensor to disengage the sensor from the windshield garnish molding.
3. Remove the intrusion sensor from the windshield garnish molding.
Installation Procedure
1. Install the intrusion sensor in to the windshield garnish molding.
2. Push on the sensor to engage the sensor into place.
3. Install the windshield upper garnish molding. Refer to Windshield Upper Garnish Molding Replacement (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.