Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-6.2LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSRAIN SENSORSERVICE AND REPAIR
2009 Chevrolet Corvette V8-6.2L
Rain Sensor: Service and Repair
2009 Chevrolet Corvette V8-6.2LSECTION Service and Repair
Windshield Outside Moisture Sensor Replacement
Removal Procedure
Important: The windshield outside moisture sensor coupler is permanently mounted to the windshield and is not serviceable. Damage to the windshield or the windshield outside moisture sensor coupler will occur, if removed.
1. Remove the trim cover from the windshield outside moisture sensor.
2. Release the windshield outside moisture sensor coupler retaining clips.
3. Remove the windshield outside moisture sensor from the windshield coupler.
4. Disconnect the windshield outside moisture sensor electrical connector.
Installation Procedure
1. Connect the windshield outside moisture sensor electrical connector.
2. Position the windshield outside moisture sensor to the windshield coupler.
3. Fasten the windshield coupler retainer clips.
4. Position the trim cover to the windshield outside moisture sensor.
5. Press the trim cover inward to secure the trim cover to the windshield outside moisture sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.