Catalyst Shield: Service and Repair

2009 Chevrolet Corvette V8-6.2LSECTION Service and Repair



Catalytic Converter Heat Shield Replacement

Removal Procedure




1. Remove the catalytic converters. Refer to Catalytic Converter Replacement - Left Side (7.0L) (Catalytic Converter Replacement - Left Side (7.0L)) and Catalytic Converter Replacement - Right Side (7.0L) (Catalytic Converter Replacement - Right Side (7.0L)).
2. Drill out the catalytic converter heat shield rivets.
3. Remove the catalytic converter heat shield.

Installation Procedure




1. Install the catalytic converter heat shield.
2. Install new catalytic converter heat shield rivets.
3. Install the catalytic converters. Refer to Catalytic Converter Replacement - Left Side (7.0L) (Catalytic Converter Replacement - Left Side (7.0L)) and Catalytic Converter Replacement - Right Side (7.0L) (Catalytic Converter Replacement - Right Side (7.0L)).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.