SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-6.2LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGBLOWER MOTORSERVICE AND REPAIR
2009 Chevrolet Corvette V8-6.2L

Blower Motor: Service and Repair

2009 Chevrolet Corvette V8-6.2LSECTION Service and Repair



Blower Motor Replacement

Removal Procedure

1. Remove the right hand (RH) insulator panel. Refer to Instrument Panel Insulator Panel Replacement (Service and Repair).

Warning

Unplug the blower motor before removal. Blower motor case contact with any ground may start the fan and cause personal injury.

Note: The blower motor resistor is internal to the blower motor assembly and is not serviced separately.

2. Disconnect the blower motor electrical connector.




3. Remove the blower motor retaining screws.
4. Remove the blower motor from the HVAC module.

Installation Procedure




1. Install the blower motor to the HVAC module.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the blower motor retaining screws.

Tighten the screws to 1.6 Nm (14 lb in).

3. Connect the blower motor electrical connector.
4. Install the RH insulator panel. Refer to Instrument Panel Insulator Panel Replacement (Service and Repair).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.