SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-6.2LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGAIR DUCTSERVICE AND REPAIRAIR DISTRIBUTOR DUCT REPLACEMENT
2009 Chevrolet Corvette V8-6.2L

Air Distributor Duct Replacement

2009 Chevrolet Corvette V8-6.2LSECTION Air Distributor Duct Replacement



Air Distributor Duct Replacement

Removal Procedure




1. Remove the instrument panel (I/P) assembly. Refer to Instrument Panel Assembly Replacement (Service and Repair).
2. Remove the bolts and screws retaining the air distribution duct to the underside of the I/P assembly.
3. Remove the air distribution duct.
4. Remove the discharge temperature management (DTM) sensors from the air distribution duct.

Installation Procedure

1. Install the DTM sensors to the air distribution duct.




2. Install the air distribution duct into position on the I/P assembly.
3. Install the retaining bolts and screws to the underside of the I/P assembly.

Tighten the screws to 1.6 Nm (14 lb in).

4. Install the I/P assembly. Refer to Instrument Panel Assembly Replacement (Service and Repair).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.