Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-6.2LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINEINTAKE MANIFOLDSERVICE AND REPAIRUPPER INTAKE MANIFOLD SIGHT SHIELD REPLACEMENT
2009 Chevrolet Corvette V8-6.2L
Upper Intake Manifold Sight Shield Replacement
2009 Chevrolet Corvette V8-6.2LSECTION Upper Intake Manifold Sight Shield Replacement
Upper Intake Manifold Sight Shield Replacement (w/o LS9) (w/o 6.2L SC)
Removal Procedure
1. Remove the oil filler cap (1), if needed.
2. Remove the right engine sight shield (2), if needed.
3. Remove the left engine sight shield (3), if needed.
Installation Procedure
1. Install the left engine sight shield (3), if needed.
2. Install the right engine sight shield (2), if needed.
3. Install the oil filler cap (1), if needed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.