Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CORVETTE V8-6.2LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSACCELERATION/DECELERATION SENSORSERVICE AND REPAIR
2009 Chevrolet Corvette V8-6.2L
Acceleration/Deceleration Sensor: Service and Repair
2009 Chevrolet Corvette V8-6.2LSECTION Service and Repair
Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement
Removal Procedure
1. Turn the ignition switch to the OFF position.
2. Remove the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair).
3. Remove the HVAC Control Module. Refer to HVAC Control Module Replacement (Service and Repair).
4. Disconnect the yaw rate sensor electrical connector.
5. Remove the two yaw rate sensor nuts (2).
6. Remove the yaw rate sensor (1).
Installation Procedure
1. Position the yaw rate sensor in the vehicle (1).
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the yaw rate sensor bolts (2).
Tighten the bolts to 7 Nm (62 lb in).
3. Connect the yaw rate sensor electrical connector.
4. Install the HVAC Control Module. Refer to HVAC Control Module Replacement (Service and Repair).
5. Install the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair).
6. Turn the ignition switch to the ON position, engine off.
7. Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.