Ignition Lock Key Transmitter Antenna Replacement - Left Side

2009 Chevrolet Corvette V8-6.2LSECTION Ignition Lock Key Transmitter Antenna Replacement - Left Side



Ignition Lock Key Transmitter Antenna Replacement - Left Side

Removal Procedure

1. Remove Rear Wheel (drivers side) - left. Refer to Tire and Wheel Removal and Installation (Service and Repair).
2. Remove the rear wheel liner. Refer to Rear Wheelhouse Panel Liner Replacement (Service and Repair).
3. Disconnect the electrical connector.




4. Disconnect left antenna from snap fit mounting - left.

Installation Procedure




1. Push on the antenna to engage the antenna to the retaining bracket.
2. Connect the antenna wire lead to the antenna.
3. Install the rear wheel liner. Refer to Rear Wheelhouse Panel Liner Replacement (Service and Repair).
4. Install the rear wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.