Ignition Lock Key Transmitter Antenna Replacement - Instrument Panel

2009 Chevrolet Corvette V8-6.2LSECTION Ignition Lock Key Transmitter Antenna Replacement - Instrument Panel



Ignition Lock Key Transmitter Antenna Replacement - Instrument Panel

Removal Procedure

1. Open the instrument panel (I/P) compartment door.
2. Remove the I/P compartment. Refer to Instrument Panel Compartment Replacement (Service and Repair).




3. Remove the I/P antenna by pulling to disengage the antenna from the retaining bracket.
4. Disconnect the lead connector from the antenna wire harness.

Installation Procedure




1. Position the antenna to the I/P carrier.
2. Connect the wire harness lead to the antenna.
3. Push on the antenna to install the antenna to the retaining bracket.
4. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement (Service and Repair).
5. Close the I/P compartment door.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.