Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009COBALT L4-2.2LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULOUTPUT SPEED SENSOR INSTALLATION
2009 Chevrolet Cobalt L4-2.2L
Output Speed Sensor Installation
2009 Chevrolet Cobalt L4-2.2LSECTION Output Speed Sensor Installation
Output Speed Sensor Installation
1. Inspect the vehicle speed sensor (62) for damage to the sensor, the electrical connector, or the O-ring (63).
2. Clean and dry the vehicle speed sensor (62).
3. Install the O-ring (63) onto the speed sensor (62).
4. Install the speed sensor (62) into the transmission case.
Caution: Refer to Fastener Caution (Fastener Caution).
5. Install the speed sensor stud (61). Tighten the speed sensor stud to 12 Nm (9 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.