Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008TAHOE 4WD V8-6.0L HYBRIDREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYLOCATIONSINSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWS
2008 Chevrolet Tahoe 4WD V8-6.0L Hybrid
Instrument Panel/Center Console Component Views
2008 Chevrolet Tahoe 4WD V8-6.0L HybridSECTION Instrument Panel/Center Console Component Views
Instrument Panel/Center Console Component Views
Front of the I/P Components (X88/Z88)
Front of the I/P (Except Z75):
1 - Turn Signal Multifunction Switch
2 - Inflatable Restraint Steering Wheel Module Coil
3 - Instrument Panel Cluster (IPC)
4 - Tow/Haul Switch
5 - Driver Information Center (DIC) Switch
6 - Ambient Light/Sunload Sensor Assembly (CJ2) or Ambient Light Sensor (CJ3)
7 - HVAC Control Module
8 - Auxiliary Power Outlet - Front 2
9 - I/P Multifunction Switch Assembly
10 - Auxiliary Power Outlet - Front 1
11 - Radio
12 - Transfer Case Shift Control Switch (NP8)
13 - Headlamp and Panel Dimmer Switch
Front of the I/P Components (Z75)
1 - Instrument Panel Cluster (IPC)
2 - Driver Information Center (DIC) Switch
3 - Ambient Light/Sunload Sensor Assembly (CJ2)
4 - Speaker - Center (UQS)
5 - Analog Clock
6 - Radio
7 - Traction Control/Rear Object Detection Switch
8 - HVAC Control Module
9 - I/P Multifunction Switch Assembly
10 - Auxiliary Power Outlet - Front 1
11 - Noise Compensation Microphone (+UQ/Y91 +UQA)
12 - Transfer Case Shift Control Switch (NP8)
13 - Fuse Block - I/P
14 - Headlamp and Panel Dimmer Switch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.