Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008SILVERADO 3500 2WD V8-6.0LREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGELECTRONIC BRAKE CONTROL MODULE PROGRAMMING AND SETUP
2008 Chevrolet Silverado 3500 2WD V8-6.0L
Electronic Brake Control Module Programming and Setup
2008 Chevrolet Silverado 3500 2WD V8-6.0LSECTION Electronic Brake Control Module Programming and Setup
Electronic Brake Control Module Programming and Setup
EBCM Replacement
If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:
EBCM Reprogramming.
EBCM Reprogramming
If the EBCM needs to be reprogrammed, refer to Service Programming System (SPS). Programming and Relearning
Setup for Component Replacement
The brake fluid pressure sensor is not serviceable. After replacing a brake fluid presure sensor, it may be necessary to perform a brake pressure sensor calibration with the Tech 2 special function, if the DTC resets as a current code.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.