Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008SILVERADO 3500 2WD V8-6.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL TANK PRESSURE SENSORSERVICE AND REPAIR
2008 Chevrolet Silverado 3500 2WD V8-6.0L
Fuel Tank Pressure Sensor: Service and Repair
2008 Chevrolet Silverado 3500 2WD V8-6.0LSECTION Service and Repair
Fuel Tank Pressure Sensor Replacement (35 Reg/Ext/Crew Cab w/34 gal Tank)
Removal Procedure
1. Remove the fuel tank.
2. Remove the fuel tank pressure sensor by pulling straight up using a slight rocking motion.
Installation Procedure
1. Install the fuel tank pressure sensor.
2. Install the fuel tank.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.