Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008SILVERADO 3500 2WD V8-6.0LREPAIR AND DIAGNOSISDIAGRAMSEXPLODED VIEWSSTEERING COLUMN
2008 Chevrolet Silverado 3500 2WD V8-6.0L
Steering Column
2008 Chevrolet Silverado 3500 2WD V8-6.0LSECTION Steering Column
Steering Column Disassembled View
Disassembled View
Steering Column Disassembled View:
1 - Steering Column Shroud
2 - Theft Deterrent Module
3 - Ignition Lock Cylinder Case
4 - Ignition Lock Cylinder Case Screw
5 - Steering Shaft Upper Bearing Spring
6 - Turn Signal Switch Cancel Cam
7 - Turn Signal Switch Cancel Cam Position Plate
8 - Steering Shaft Lock Plate Retaining Ring
9 - Inflatable Restraint Steering Wheel Module Coil Wave Washer
10 - Inflatable Restraint Steering Wheel Module Coil Retaining Ring
11 - Inflatable Restraint Steering Wheel Module Coil
12 - Steering Shaft Upper Bearing Race Seat
13 - Turn Signal Multifunction Switch Bolt
14 - Turn Signal Multifunction Switch
15 - Ignition Lock Cylinder Case Bracket
16 - Steering Column Pivot Pin
17 - Spring Guide
18 - Tilt Lever
19 - Shift Lever Seal
20 - Steering Column Shroud
21 - Tilt Spring
22 - Steering Column
23 - Steering Wheel Position Sensor Retaining Clip
24 - Steering Wheel Position Sensor
25 - Steering Shaft Lower Bearing
26 - Automatic Transmission Shift Lock Actuator
27 - Steering Column Bracket Screw
28 - Automatic Transmission Control
29 - Automatic Transmission Control Bolt
30 - Shift Lever Bolt
31 - Ignition/Start Switch
32 - Steering Shaft Upper Bearing
33 - Shift Lever
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.