Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008MALIBU L4-2.4L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL TANK PRESSURE SENSORSERVICE AND REPAIR
2008 Chevrolet Malibu L4-2.4L Hybrid
Fuel Tank Pressure Sensor: Service and Repair
2008 Chevrolet Malibu L4-2.4L HybridSECTION Service and Repair
Fuel Tank Pressure Sensor Replacement
Removal Procedure
1. Remove the fuel tank.
2. Disconnect the fuel tank fuel pump module wiring harness electrical connector (2) from the fuel tank pressure sensor.
3. Gently pull upward in order to remove the fuel tank pressure sensor from the fuel tank module.
Installation Procedure
1. Lightly lubricate the sensor seal with clean engine oil.
2. Press the sensor down fully into the fuel tank module.
3. Connect the fuel tank fuel pump module wiring harness electrical connector (1) to the fuel tank pressure sensor.
4. Install the fuel tank.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.