Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008MALIBU L4-2.4L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIR
2008 Chevrolet Malibu L4-2.4L Hybrid
Crankshaft Position Sensor: Service and Repair
2008 Chevrolet Malibu L4-2.4L HybridSECTION Service and Repair
Crankshaft Position Sensor Replacement
Removal Procedure
1. Remove the starter.
2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
3. Remove the CKP sensor bolt.
4. Remove the CKP sensor.
Installation Procedure
1. Lubricate the CKP sensor O-ring seal with clean engine oil.
2. Install the CKP sensor.
Notice: Refer to Fastener Notice.
3. Install the CKP sensor bolt.
Tighten the sensor bolt to 10 N.m (89 lb in).
4. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
5. Install the starter.
6. Perform the crankshaft position system variation learn procedure. Refer to Crankshaft Position System Variation Learn. Service and Repair
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.