Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008MALIBU L4-2.4L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR FLOW METER/SENSORSERVICE AND REPAIR
2008 Chevrolet Malibu L4-2.4L Hybrid
Air Flow Meter/Sensor: Service and Repair
2008 Chevrolet Malibu L4-2.4L HybridSECTION Service and Repair
Mass Airflow Sensor/Intake Air Temperature Sensor Replacement
Removal Procedure
1. Disconnect the engine wiring harness electrical connector (1) from the mass air flow (MAF)/intake air temperature (IAT) sensor (2).
2. Remove the MAF/IAT sensor screws (1).
3. Remove the MAF/IAT sensor (2).
Installation Procedure
1. Install the MAF/IAT sensor (2).
Notice: Refer to Fastener Notice.
2. Install the MAF/IAT sensor screws (1).
Tighten the screws to 0.6 N.m (5 lb in).
3. Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.