Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008IMPALA V8-5.3LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER RELAYLOCATIONS
2008 Chevrolet Impala V8-5.3L
Windshield Washer Relay: Locations
2008 Chevrolet Impala V8-5.3LSECTION Locations
WINDSHIELD WASHER RELAY
The Windshield Washer PCB relay is located in the Underhood Fuse Block (1). The Underhood Fuse Block (1) is located on the right side of the engine compartment, mounted to the strut tower.
IMPORTANT: This relay is a Printed Circuit Board (PCB) relay, and is only repaired by replacing the Underhood Fuse Block.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.