Torque Converter: Service and Repair

2008 Chevrolet Impala V8-5.3LSECTION Service and Repair


Flywheel to Torque Converter Bolt Replacement

Tools Required

J 37096 Flywheel Holder


Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the torque converter cover bolts.
3. Remove the torque converter covers.




4. Install the J 37096 in order to gain access to the torque converter bolts and to prevent the flywheel from turning.




5. Remove the flywheel to torque converter bolts.



Installation Procedure





1. Install the J 37096 in order to gain access to the torque converter bolts and to prevent the flywheel from turning.





Notice: Refer to Fastener Notice .

2. Install the flywheel to torque converter bolts.

Tighten the bolts to 63 N.m (46 lb ft).





3. Install the torque converter covers.
4. Install the torque converter cover bolts.

Tighten the bolts to 10 N.m (89 lb in)

5. Lower the vehicle.


RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.