Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR L4-2.4LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSYAW RATE SENSORSERVICE AND REPAIR
2008 Chevrolet HHR L4-2.4L
Yaw Rate Sensor: Service and Repair
2008 Chevrolet HHR L4-2.4LSECTION Service and Repair
Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement
Removal Procedure
1. Turn OFF the ignition.
2. Remove the right front seat. Refer to Front Seat Replacement - Bucket (Front Seat Replacement - Bucket) .
3. Remove the right side body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side (Service and Repair) .
4. Carefully lift the floor carpet to access the yaw rate sensor.
5. Disconnect the yaw rate sensor electrical connector.
6. Remove the yaw rate sensor nuts (1).
7. Remove the yaw rate sensor (1).
Installation Procedure
1. Install the yaw rate sensor (1).
Notice: Refer to Fastener Notice (Fastener Notice) .
2. Install the yaw rate sensor nuts (1).
Tighten the nuts to 10 N.m (89 lb in).
3. Connect the yaw rate sensor electrical connector.
4. Carefully position the floor carpet to the vehicle floor.
5. Install the right side body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side (Service and Repair) .
6. Install the right front seat. Refer to Front Seat Replacement - Bucket (Front Seat Replacement - Bucket) .
7. Install a scan tool.
8. Using the special functions menu on the scan tool, reset the yaw rate sensor.
9. Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.