Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR L4-2.2LREPAIR AND DIAGNOSISBODY AND FRAMEAUXILIARY STEP / RUNNING BOARDSERVICE AND REPAIRASSIST STEP REPLACEMENT (BVE)
2008 Chevrolet HHR L4-2.2L
Assist Step Replacement (BVE)
2008 Chevrolet HHR L4-2.2LSECTION Assist Step Replacement (BVE)
Assist Step Replacement (BVE)
Preliminary Procedure
Notice:Refer to.
TightenTighten
TipRelease the retainer clips from the front fender flange and bodyside panel.
TipPosition the assist step locator pin into the bodyside panel upon installation of the assist step.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.