Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER MOTORSERVICE AND REPAIRWINDSHIELD WIPER MOTOR REPLACEMENT
2008 Chevrolet Express 2500 V8-4.8L
Windshield Wiper Motor Replacement
2008 Chevrolet Express 2500 V8-4.8LSECTION Windshield Wiper Motor Replacement
Windshield Wiper Motor Replacement
Tools Required
* J39232 Wiper Transmission Separator
* J39529 Wiper Transmission Installer
Removal Procedure
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the wiper transmission.
4. Remove the 2 bolts retaining the wiper motor.
5. Remove the wiper motor from the wiper transmission.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the wiper motor onto the wiper transmission with the 2 bolts.
Tighten to 8 N.m (71 lb in).
2. Install the wiper transmission assembly.
3. Install the air inlet grille panel.
4. Install the wiper arms.
5. Operate the wipers and inspect for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.