Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHIGNITION SWITCH LOCK CYLINDERLOCATIONS
2008 Chevrolet Express 2500 V8-4.8L
Ignition Switch Lock Cylinder: Locations
2008 Chevrolet Express 2500 V8-4.8LSECTION Locations
Instrument Panel/Center Console Component Views
Upper Steering Column
1 - Passlock Sensor
2 - Ignition Key Alarm Switch
3 - Ignition Lock Cylinder Control Actuator
4 - Ignition Switch
5 - Ignition Key Cylinder
6 - Horn Switch
7 - Inflatable Restraint Steering Wheel Module
8 - Turn Signal/Multifunction Switch
9 - Hazard Switch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.