Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSCOMBINATION SWITCHLOCATIONS
2008 Chevrolet Express 2500 V8-4.8L
Combination Switch: Locations
2008 Chevrolet Express 2500 V8-4.8LSECTION Locations
Instrument Panel/Center Console Component Views
Instrument Panel Components
1 - Turn Signal/Multifunction Switch
2 - Driver Information Center (DIC)
3 - Steering Wheel Controls - Left (K34)
4 - Instrument Panel Cluster (IPC)
5 - Inflatable Restraint Steering Wheel Module
6 - Steering Wheel Controls - Right (W1Y)
7 - Instrument Panel
8 - Tow/Haul Switch
9 - HVAC Control Assembly
10 - Radio
11 - Inflatable Restraint Instrument Panel Module
12 - Instrument Panel Compartment Lamp
13 - Auxiliary Power Outlet 2
14 - Blower Motor Switch - Auxiliary (C36 -C69)
15 - Inflatable Restraint PASSENGER AIR BAG ON/OFF Indicator
16 - Inflatable Restraint Instrument Panel Module Disable Switch
18 - Auxiliary Power Outlet 1
19 - Data Link Connector (DLC)
20 - Headlamp Dimmer Switch
21 - Headlamp Switch
Upper Steering Column
1 - Passlock Sensor
2 - Ignition Key Alarm Switch
3 - Ignition Lock Cylinder Control Actuator
4 - Ignition Switch
5 - Ignition Key Cylinder
6 - Horn Switch
7 - Inflatable Restraint Steering Wheel Module
8 - Turn Signal/Multifunction Switch
9 - Hazard Switch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.