Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISINSTRUMENT PANEL, GAUGES AND WARNING INDICATORSAUDIBLE WARNING DEVICE CONTROL MODULESERVICE AND REPAIR
2008 Chevrolet Express 2500 V8-4.8L
Audible Warning Device Control Module: Service and Repair
2008 Chevrolet Express 2500 V8-4.8LSECTION Service and Repair
Multifunction Alarm Module Replacement
Removal Procedure
1. Remove the driver side knee bolster bracket.
2. Disconnect the multifunction audio alarm module (2) electrical connector (1).
3. Remove the multifunction audio alarm module (2) from the vehicle.
Installation Procedure
1. Install the multifunction audio alarm module (2) to the mag beam.
2. Connect the electrical connector (1) to the multifunction audio alarm module (2).
3. Install the driver side knee bolster bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.