Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGREFRIGERANT PRESSURE SENSOR / SWITCHLOW PRESSURE SENSOR / SWITCHSERVICE AND REPAIR
2008 Chevrolet Express 2500 V8-4.8L
Low Pressure Sensor / Switch: Service and Repair
2008 Chevrolet Express 2500 V8-4.8LSECTION Service and Repair
Air Conditioning (A/C) Low Pressure Switch Replacement
Tools Required
J 39400-A Halogen Leak Detector
Removal Procedure
1. Disconnect the low pressure switch electrical connector (2).
2. Remove the low pressure switch (1) from the accumulator.
3. Remove the O-ring seal.
Installation Procedure
1. Install the new O-ring seal to the switch.
Notice: Refer to Fastener Notice.
2. Install the A/C low pressure switch (1) to the accumulator.
Tighten the switch to 4 N.m (35 lb in).
3. Connect the low pressure switch electrical connector (2).
4. Leak test the fittings of the component using the J 39400-A.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.