Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLHYDRAULIC SYSTEMBRAKE FLUID LEVEL SENSOR/SWITCHLOCATIONS
2008 Chevrolet Express 2500 V8-4.8L
Brake Fluid Level Sensor/Switch: Locations
2008 Chevrolet Express 2500 V8-4.8LSECTION Locations
Front of Vehicle/Engine Compartment Component Views
Engine Compartment
1 - Vacuum Pump (6.6L)
2 - Battery
3 - Transmission Control Module (TCM)
4 - Blower Motor Resistor Assembly
5 - Blower Motor
6 - Cruise Control Module (LU3)/Throttle Actuator Control (TAC) Module (-LU3)
7 - Brake Fluid Level Switch
8 - Engine Control Module (ECM)
9 - Fuse Block - Underhood
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.