Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMSERVICE AND REPAIRFRONT BRAKE SHIELD REPLACEMENT
2008 Chevrolet Express 2500 V8-4.8L
Front Brake Shield Replacement
2008 Chevrolet Express 2500 V8-4.8LSECTION Front Brake Shield Replacement
Front Brake Shield Replacement
Removal Procedure
Caution: Refer to Brake Dust Caution .
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove the hub and bearing assembly (5). Refer to Front Wheel Hub, Bearing, and Seal Replacement (RWD) Front Wheel Hub, Bearing, and Seal Replacement (4WD) .
4. Remove the splash shield (6), for 15 series.
5. Remove the splash shield, for 25/35 series.
Installation Procedure
1. Install the splash shield (6), for 15 series.
2. Install the splash shield, for 25/35 series.
3. Install the hub and bearing assembly (5). Refer to Front Wheel Hub, Bearing, and Seal Replacement (RWD) Front Wheel Hub, Bearing, and Seal Replacement (4WD) .
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
5. Remove the safety stands.
6. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.