Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISBODY AND FRAMEFRAMESKID PLATESERVICE AND REPAIR
2008 Chevrolet Express 2500 V8-4.8L
Skid Plate: Service and Repair
2008 Chevrolet Express 2500 V8-4.8LSECTION Service and Repair
Engine Protection Shield Replacement
Removal Procedure
1.Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2.Remove the engine protection shield mounting bolts, light duty shown, heavy duty similar.
1.Remove the engine protection shield.
Installation Procedure
1.Install the engine protection shield.
Notice:Refer to Fastener Notice .
1.Install the engine protection shield mounting bolts, light duty shown, heavy duty similar.
TightenTighten the bolts to 20 N �m (15 lb ft).
2.Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.