SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISBODY AND FRAMECOWLSERVICE AND REPAIR
2008 Chevrolet Express 2500 V8-4.8L

Cowl: Service and Repair

2008 Chevrolet Express 2500 V8-4.8LSECTION Service and Repair


Air Inlet Grille Panel Replacement

Removal Procedure

1. Raise and support the hood.





2. Remove the screws (1-7), retaining the air inlet grille panels to the cowl vent.
3. Remove the wiper arms from the vehicle.
4. Disconnect the washer hoses from the air inlet grille panel.
5. Remove the air inlet grille panels from the vehicle.

Installation Procedure





1. Install the air inlet grille panels to the vehicle.
2. Align the retainers in the body with the tabs on the grille panel. Press the retainers into place.
3. Connect the washer hoses to the air inlet grille panel.
4. Install the wiper arms to the vehicle.

Notice: Refer to Fastener Notice.

5. Install the screws in sequential order (1-7), to retain the air inlet grille panels to the cowl vent.

Tighten the screws in sequential order to 1.7 N.m (15 lb in).

6. Close the hood.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.