Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008COLORADO 2WD L5-3.7LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMSERVICE AND REPAIRFRONT BRAKE SHIELD REPLACEMENT
2008 Chevrolet Colorado 2WD L5-3.7L
Front Brake Shield Replacement
2008 Chevrolet Colorado 2WD L5-3.7LSECTION Front Brake Shield Replacement
Front Brake Shield Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the wheel hub and speed sensor. Refer to Wheel Hub/Speed Sensor Replacement (Service and Repair) .
3. Remove the disc brake splash shield.
Installation Procedure
1. With the aid of an assistant, hold 2 of the 4 mounting bolts in the steering knuckle across from each other.
2. Position the splash shield on the steering knuckle.
3. Install the wheel hub and speed sensor assembly. Refer to Wheel Hub/Speed Sensor Replacement (Service and Repair) .
4. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.