Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008COLORADO 2WD L5-3.7LREPAIR AND DIAGNOSISBODY AND FRAMEFRAMESKID PLATESERVICE AND REPAIR
2008 Chevrolet Colorado 2WD L5-3.7L
Skid Plate: Service and Repair
2008 Chevrolet Colorado 2WD L5-3.7LSECTION Service and Repair
Engine Protection Shield Replacement
Removal Procedure
1.Remove the front shield bolts (1, 2).
2.Remove the front shield from the vehicle.
1.Remove the rear shield bolts (1, 2).
2.Remove the rear shield from the vehicle.
Installation Procedure
1.Install the rear shield to the vehicle.
Notice:Refer to Fastener Notice .
2.Install the rear shield bolts (1).
TightenTighten the bolts to 75 N �m (55 lb ft).
3.Install the rear shield bolts (2).
TightenTighten the bolts to 20 N �m (15 lb ft).
1.Install the front shield to the vehicle.
2.Install the front shield bolts (1).
TightenTighten the bolts to 60 N �m (44 lb ft).
3.Install the front shield bolts (2).
TightenTighten the bolts to 20 N �m (15 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.