Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008COLORADO 2WD L5-3.7LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTNAVIGATION SYSTEMSERVICE AND REPAIR
2008 Chevrolet Colorado 2WD L5-3.7L
Navigation System: Service and Repair
2008 Chevrolet Colorado 2WD L5-3.7LSECTION Service and Repair
Navigation Control Processor Bracket Replacement
Removal Procedure
1. Remove the OnStar(R) vehicle communication interface module (VCIM). Refer to Communication Interface Module Replacement (Service and Repair) .
2. Remove the nuts (1) retaining the navigation control processor bracket to the instrument panel (I/P) structure.
3. Remove the bracket from the vehicle.
Installation Procedure
1. Install the bracket to the I/P structure.
Notice: Refer to Fastener Notice.
2. Install the nuts (1) retaining the bracket to I/P structure.
Tighten the fasteners to 9 N.m (80 lb in).
3. Install the VCIM. Refer to Communication Interface Module Replacement (Service and Repair) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.