Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 3500 2WD V8-6.0LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIR
2007 Chevrolet Silverado Classic 3500 2WD V8-6.0L
Body Control Module: Service and Repair
2007 Chevrolet Silverado Classic 3500 2WD V8-6.0LSECTION Service and Repair
BODY CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. CAUTION: Refer to Battery Disconnect Caution.
Disconnect the negative battery cables.
2. Remove the knee bolster.
3. Disconnect the brown connector.
4. Disconnect all other connectors (1).
5. Remove the body control module (BCM) from the sliding bracket.
INSTALLATION PROCEDURE
1. Slide the BCM onto the bracket.
2. Connect all the connectors (1) except the brown connector.
3. Connect the brown connector.
4. Install the knee bolster.
5. Connect the negative battery cables.
6. Reprogram the BCM. Refer to Body Control Module Programming and Setup.
7. Perform the Passlock Learn Procedure. Refer to Programming Theft Deterrent System Components.
8. Refer to Control Module References for programming and setup information. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.